Address
Recipient e-mail address 1, 2, 3
Type the recipient e-mail address using up to 64
characters.
You can specify up to three recipient e-mail addresses.
Administrator e-mail address
Type the Administrator e-mail address using up to 64
characters.
This address is used for reply e-mails and sending
system messages from the mail server.
Content
Subject
Type the subject/title of the e-mail using up to 64
characters.
An e-mail sent in response to alarm detection will
indicate the type of alarm in the subject. (Sensor1) is
added for sensor input 1 detection, (Sensor2) for sensor
input 2 detection, (Tampering) for camera interference
detection, (VMD) for motion detection, (VMF) for
VMF detection, (Disconnected) for network
disconnection detection, (Face Detection) for face
detection. (Event1 (Condition1)) is additionally
available for event condition detection.
Message
Type the text of the e-mail using up to 384 characters. (A
line break is equivalent to 2 characters.)
Event triggered execution
File attachment
Set whether an image file (JPEG file) is to be attached to
the e-mail or not.
When the checkbox is selected, the image file made
using the settings below is attached. When the checkbox
is deselected, only the message is sent.
Image file name
Type the file name you want to assign to the image to be
attached to an e-mail. You can use up to 10
alphanumeric characters, – (hyphen) and _ (underscore)
for naming.
Suffix
Select a suffix to be added to the file name used when the
e-mail is sent.
None: The name of the sent file will be the image file
name.
Page 47