Faults and what to do about them
en
Faults
Drying time too long?
Display panel goes off
and Start button flashes.
Residual water in the con-
densate container despite
the dryer being con-
nected to the condensa-
tion drain*.
Humidity in the room
increases.
Power cut.
Unusual noises when dry-
ing.
The dryer feels cold
despite drying.
* depending on the model
If you cannot rectify the fault yourself by turning the dryer off and on, please
Note:
contact our after-sales service.
26
Cause/remedy
The fluff filter may be dirty and cause drying to take longer. Clean the fluff
■
filter.
If the air inlet on the dryer is blocked or not freely accessible, this may
■
increase the drying time. Make sure that the air inlet remains unobstructed.
If the ambient temperature is higher than 35 °C, this may extend the drying
■
time.
Insufficient air circulation in the room may increase the drying time. Venti-
■
late the room.
Not a fault. Energy saving mode is active .
Not a fault. If the condensation drain is installed, residual water remains in the
condensate container due to the dryer's self-cleaning function.
Not a fault. Make sure the room is sufficiently ventilated.
The drying programme is interrupted. Remove the laundry and spread it out, or
restart the programme.
Not a fault. Noises are produced by the automatic cleaning of the heat
exchanger .
Not a fault. The dryer can dry efficiently at low temperatures using a heat pump.