Advertisement
BATTERY LOW MODE
If you have inserted batteries, the battery low indicator
• battery power is low.
During the battery low mode, both Radio/Sleep, sound effects, backlight will not
function.
Operation of any alarm mode (Radio/Buzzer/Submarine/Frog) automatically changes to
a slow buzzer beep frequency.
• If the RADIO ON / OFF, ALARM RESET / SLEEP or
REPEAT ALARM•BRIGHTNESS CONTROL button is pressed, the battery
low indicator will flash for 5 seconds and then remains non-blinking.
GENERAL FEATURES
Reset
Should you receive external interference e.g. static electricity from carpets, thunder-
storms, etc. Which affects the display and electronic functions of your set, RESET
allows you to clear all previous settings and start up again.
• Use a ballpoint pen to press RESET , found inside battery compartment.
Demo mode
When the set is first connected to a power supply or has been reset, 'PHILIPS' will
scroll continuously across the demonstration display.
• Press SET AL / TIME to exit the demo mode, before you set the times or
press RADIO ON / OFF or ALARM RESET / SLEEP to switch on the Radio.
Illumination brightness
Press REPEAT ALARM•BRIGHTNESS CONTROL once or more.
• The brightness of the display will change in this sequence:
➟
off
bright (5 seconds)
Note:
When the alarm or SLEEP function is active, the brightness cannot be adjusted.
lights up when:
➟
OFF (for batteries)
SETTING THE CLOCK AND ALARM TIMES
The time is displayed using the 12-hour clock with PM indicator (PM off = AM).
Setting the clock time
1. Press SET AL / TIME twice within a second to
the clock time setting mode.
™ The clock time display flashes and you will hear a
short beep.
2. Hold down or press HOUR + or MIN + repeatedly to
set and adjust the hours and minutes respectively.
Release HOUR + or MIN + when you have reached the
correct setting.
3. After both the hours and minutes are set, press SET AL
/ TIME to confirm the setting.
™ You will hear two short beeps.
Setting the alarm time
1. Press SET AL / TIME once to enter the alarm time setting mode.
™
lights up and the alarm time display flashes. You will hear a short beep.
2. Hold down or press HOUR + or MIN + repeatedly to set and adjust the hours
and minutes respectively. Release HOUR + or MIN + when you have reached
the correct setting.
3. After both the hours and minutes are set, press SET AL / TIME to confirm the
setting.
™ You will hear two short beeps.
™ Display returns to clock time.
• Time setting is also automatically confirmed after 10 seconds after you set the time.
• It is not possible to adjust the alarm time during an alarm call or the repeat
alarm mode.
RADIO (FM only)
1 Press RADIO ON / OFF once to switch on the radio.
™ Display shows 'ON' shortly.
2 Adjust TUNING to find your radio station.
3 Adjust the sound using VOLUME.
4 Press RADIO ON / OFF to switch off.
To improve reception:
• Extend and position the pigtail fully to obtain optimum reception.
enter
PM
Advertisement
