Making The Connections; Removing The Module - OSEE VAC6840N User Manual

VAC6840N Video & Audio 2X1 Switcher
Step3
Step 4
Step5
 Locate the position for back connector and insert the back connector
 Fasten the screw to fix the back connector.
 Locate the slot for module.
 Get the module installed in the slot, push the module slightly along the slot, press module again to
confirm that the module is installed firmly and then close swivel handle.
 Install the front panel.

2.4 Making the Connections

Please connect signals based on Fig. 1-2.

2.5 Removing the Module

Follow the following steps to remove VAC6840N module:
1. Open the front part of frame.
2. Open the swivel handle to the full.
3. First make sure the frame stands firmly, and then pull the module gently along the slot till out
of frame.
4. Install the front panel.
Specifications are subject to change without notice.
Fig. 2-1 Installation of 2U Frame of 6800N Series
Operating Manual
—5—