Boss Audio Systems AR1200.2 User Manual page 7

Low Level lnput Wiring
Low-level (RCA) input wiring is preferred for best audio performance. Always use
а high-quality RCA саЫе for best audio performance.
NOTE: Do not co n nect ВОТН the high level and low level inputs fro m your
receiver your amplifier at the
to
2-Channel Amplifiers
AR1200,2, AR1600,2,
AR2600.2, and АRЗООО.2
@
@
Toдudio
Outputs of head
unit or signal
processor
4-Channel Amplifiers
AR1600.4 and AR2400.4
@
ARMOR MOSFET Amplifier User"s Manual - page 6
time!
same
Remote Subwoofer Control
-@
@
'''"'
о
@
1 0 1 11
1:::::н::::н::::11::::::н::::1�:::::1
-@
Remote Subwoofer Control
@
@
То REAR Audio Outputs of
head unit or
signal processor
High Level lnput Wiring
The high level input(s) should only Ье used when your head unit lacks RCA outputs.
lf the RCA outputs are not present, connect the speaker outputs from the receiver
to the high level input connector of the amplifier. Ве sure to observe polarity to
avoid audio phase proЫems.
NOTE: Do not connect ВОТН the high /evel and /ow /evel inputs from your
receiver your amplifier at the
to same
MonoЫock Amplifier
AR1500M
@
� �.- � .8.J.Q,. @
I.OW l'ASS MOD(
1 �ltoВ WНz Z5(1H,
ru11м•• • �
@
То Speaker Terminals
of head unit
@-
Remote Subwoofer Control
MonoЫock Amplifiers
AR2000M and AR2500M
@
INPIJf
м�:Х
а:
�@��
L+ L- R- R+
То Speaker Terminals
of head unit
time!
@
ina S!MSmvnY
L
@- �0---+t н+
-
@
�1
L+ L- R- R+
- ..... -------�..:;-�
0
""o=o=o=
.... P<IWER
@
о
"""""
l;IIOIJJDVER
ваоsт о
E.REM
:�;.
'
MDnnЫock
J:5SF
@
Remote Subwoofer Control
ARMOR MOSFET Amplifier User"s Manual - page 9