NexxTech 6319296 User Manual page 17

TEMPERATURE/ HUMIDITY WINDOW
ICON
SEARCH FOR REMOTE SENSORS
• The main unit can be manually activated to search for
the signals from remote sensors by pressing and holding
DOWN (▼) button.
OPERATION
• To select the indoor/ outdoor temperature and humidity
mode, press UP (▲) or DOWN (▼) until the IN icon
flashes with a beep sound alert.
VIEWING REMOTE (CHANNEL) TEMPERATURE
AND HUMIDITY
Static Display:
• Press the CHANNEL button to select measurements
from different remote sensors, each is MODE to a unique
channel 1, 2 or 3.
Channel Auto-Scan Display:
• To enable an automatic scan of all channels, press
and hold CHANNEL, until the icon is displayed. The
measurements from each remote channel will be
alternately displayed for 5 seconds.
NOTE: the channel auto-scan feature can be active
only if there are more than one remote sensors
operating and are set to different channels.
PROGRAMMING TEMPERATURE IN CELSIUS
OR FAHRENHEIT
• Press and hold MODE button for 3 seconds to toggle the
temperature unit in Celsius (ºC) or Fahrenheit (ºF).
STATUS
Searching for the signals from the
remote sensor
Corresponding remote sensor signal
received successfully
No signals received for over 1 hour
17