NexxTech 6319296 User Manual page 14

PRESSURE OPERATION
SEA LEVEL barometric pressure provides you with
information about pressure changes at lower elevations
in your surrounding area. The SEA LEVEL pressure
value can be set to match your local metro area weather
information. (Sources – local TV or radio station, etc.)
SETTING INITIAL PRESSURE PARAMETERS
IMPORTANT: Allow the unit to set without touching ANY
buttons for about 6-8 minutes during the main unit initial
set up. This will give the unit time to synchronize with
remotes, stabilize pressure readings and set the default
settings.
SELECT PRESSURE UNITS OF MEASURE
Press UP (▲) or DOWN (▼) until the pressure icon
"PRESSURE", to the left of the barometric pressure value,
begins to flash.
• Press MODE button, to toggle through selections until
"SEA LEVEL" or "LOCAL" barometric pressure is
displayed.
• Press and hold MEM/ HISTORY button to enter the
pressure unit selection mode. Press the UP (▲) or
DOWN (▼) button to select the preferred units of
measure for pressure: inHG (English), hPa/mBar
(scientific) or mmHg (metric).
• Press MEM/ HISTORY to confirm your selection. Then
press MODE to move to the ALTITUDE unit selection
mode. Press the UP (▲) or DOWN (▼) button to select
pressure unit as METER or FEET.
• Press MEM/ HISTORY to confirm and hold MODE to
move to the ALTITUDE value selection mode.
• Press UP (▲) or DOWN (▼) to select or adjust the
altitude value to your location. (Press and hold either
button for accelerated digit advancement.)
• Press MODE to confirm the programming selection.
NOTE: The unit will automatically exit programming mode
if no buttons are pressed after 2 minutes.
14