Table of Contents
Advertisement
Switch Installation
Connecting to Power
Single ring terminal
Two single ring terminals
To ground the switch to earth ground by using the ground screw, follow these steps:
1.
Use a standard Phillips screwdriver or a ratcheting torque screwdriver with a Phillips head to remove the ground
screw from the front panel of the switch. Store the ground screw for later use.
2.
Use the manufacturer's guidelines to determine the wire length to be stripped.
3.
Insert the ground wire into the ring terminal lug, and using a crimping tool, crimp the terminal to the wire. See
Figure 7 on page
Figure 7
Crimping the Ring Terminal
4.
Slide the ground screw through the terminal.
5.
Insert the ground screw into the functional ground screw opening on the front panel.
6.
Use a ratcheting torque screwdriver to tighten the ground screws and ring terminal to the switch front panel. The
torque should not exceed 4.5 in-lb (0.51 N-m). See
20. If two ring terminals are being used, repeat this action for a second ring terminal.
Figure 8 on page
21.
20
Hide quick links:
Advertisement
Table of Contents
