Table of Contents
Advertisement
Doc Title
:
User's Guide
Model
:
Motorola L70×CBT
1
GETTING STARTED
WARNING
․
Do not place your phone in the bathroom or other humid areas.
Location
When choosing a location for your new phone, here are some important guidelines you should consider:
․
Avoid sources of noise and heat, such as motors, fluorescent lighting, microwave ovens, heating appliances and
direct sunlight.
․
Avoid areas of excessive dust, moisture, and low temperature.
․
Avoid other cordless telephones or personal computers.
․
Never install telephone wiring during a lightning storm.
․
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
․
Never touch non-insulated telephone wires or terminals unless the telephone line has been disconnected at the
network interface.
․
Use caution when installing or modifying telephone lines.
HANDSET RANGE
Optimal range is reached when there are no other electrical appliances working within the range area. Any
obstruction between the corded base and cordless handset will also reduce the range significantly.
SIGNAL STRENGTH
When out of range of the corded base, the screen shows OUT OF RANGE. If you are on a call, the line will hang
up. Move back within range of the corded base. The cordless handset will automatically re-connect to the corded
base.
Setting up
IMPORTANT
The corded base must be plugged into an electrical outlet at all times. Do not connect the telephone line cord into
the telephone wall jack until the cordless handset is fully charged. Use only the adapter and telephone line cord
supplied with the product.
WHICH POWER ADAPTER
The power adapter with the red crystal DC plug is for the corded base unit and the power adapter with the small
round DC plug is for the cordless charger unit.
1.1 Installing and charging the cordless handset battery pack
1.
Slide off the battery compartment cover to remove it.
2.
Place the supplied rechargeable battery pack in the battery compartment, and insert the plug of the battery
pack into the socket, as shown above.
3.
Slide the battery compartment cover back on.
4.
Put the cordless handset on the cordless charger to charge for at least 24 hours. Once charging completed,
the <Battery full icon> will indicate that the handset is fully charged.
This document contains confidential and proprietary information of VTech Telecommunications Ltd
Revision :
Page(s) :
1.0
7 of 40
Advertisement
Table of Contents
