1 Safety
tact opening of at least 3 mm, e.g. fuse or
line protection switch).
▶ Secure against being switched back on
again.
▶ Check that there is no voltage.
1.4.3 Risk of being burned or scalded by
hot components
▶ Only carry out work on these components
once they have cooled down.
1.4.4 Risk of material damage caused by
using an unsuitable tool
▶ Use the correct tool to tighten or loosen
screw connections.
1.4.5 Risk of material damage caused by
frost
▶ Do not install the product in rooms prone
to frost.
1.4.6 Risk of injury during transport due
to a high product weight
▶ Make sure that the product is transported
by at least two people.
1.5
Regulations (directives, laws,
standards)
▶ Observe the national regulations, stand-
ards, guidelines and laws.
4
Installation and maintenance instructions auroSTOR 0020221298_02