Table of Contents
Advertisement
PortaSens II
Opening the Software:
The software that was previously installed on the computer can now be opened to allow
the connection to begin. An example of the icon is located below in Figure 3.
The software will open and verify that the connection to the C16 monitor is ok. If the error
message that is displayed below appears, it means the clock of the C16 is incorrect based on the
computers clock and the software is asking if it should be corrected. This error may indicate that
the data that has been collected on the device may have the incorrect times recorded if the
Troubleshooting: Should connection issues arise there are some steps that can be done to
ensure the connection and settings are correct.
1. Ensure all of the connections are properly connected and secure.
2. Make sure the software is using the correct Serial or COM port. This can be
determined in the Configure tab and Communications section as pictured below.
Data Logging Guide, Model C16
Figure 3
Figure 4
Figure 5
7
Advertisement
Table of Contents
