100 %. Info Information marked with this symbol helps you to carry out your tasks quickly and safely. Follow the manual Information marked with this symbol indicates that the operating manual must be observed. Operating manual – particle counter PC220...
• be aware of the dangers that occur when working in environments contaminated with formaldehyde. • be aware of the dangers that occur when working in environments contaminated with carbon monoxide. • have read and understood the operating manual, especially the Safety chapter. Operating manual – particle counter PC220...
Page 4
Strong lacrimation already after a few minutes of exposure (lasting for up to 1 hour after exposure), immediate breathlessness, coughing, severe burning in throat, nose and eyes 30 ppm Toxic pulmonary oedema, pneumonia, risk of death! Operating manual – particle counter PC220...
Health and Safety Ordinance on Artificial Optical Radiation (TROS) devised by the German Federal Institute for Occupational Health and Safety. Maintenance and repair work may only be carried out by trained expert staff observing the legal regulations. Operating manual – particle counter PC220...
Page 6
Temperature and humidity sensor Camera Designation USB port Colour display Electrical connection Function keys "F1", "F2" and "F3" Tripod thread Arrow key up Battery compartment "ENTER" key "RUN/STOP" key Arrow key down "On/Off" key "ESC" key Operating manual – particle counter PC220...
(50 °F to 104 °F) ±1.0 °C (1.8 °F) at Resolution 1 ppm other temperature ranges Wet-bulb temperature range 0 °C to 80 °C (32 °F to 176 °F) Wet-bulb temperature accuracy ±1.0 °C (1.8 °F) Operating manual – particle counter PC220...
• protected from dust and direct sunlight. • with a cover to protect it from invasive dust, if necessary. "F2" button SYSTEM SET – system settings "F3" button Info – Information about the device "ENTER" button "Measurement" screen Operating manual – particle counter PC220...
Page 9
– measurement settings for carbon monoxide HCHO SET – measurement settings for formaldehyde CL – Reset measured values after pressing "F3" for approx. 3 s. Is confirmed by an acoustic signal. RUN/STOP key "Measurement" screen Operating manual – particle counter PC220...
Page 10
After each measurement, a measurement log is automatically Ambient Temp/%RH Enable/disable created. If you also want to take a photo or record a video, temperature and relative humidity proceed as described in the next sections. Dewpoint/Wetbulb Enable disable dew point/wet-bulb Operating manual – particle counter PC220...
Page 11
"F3" 4. Press "ESC" to exit the photo function. 5. Insert a memory card and close the cover. 6. Put the battery back in. 7. Close the battery compartment and screw it closed again. Operating manual – particle counter PC220...
Page 12
Trotec assumes no liability with regard to this free software and also provides no support on that score. Trotec To do so, please proceed as follows: accepts no liability concerning the use of this free software and 1.
To do so, please proceed as follows: 1. Open the rubber side cover. 2. Attach the charger. 3. The loading screen is shown on the display. When the battery is fully loaded, the battery symbol is completely green. Operating manual – particle counter PC220...
Directive 2006/66/EC of the European Parliament and of the Council of 6 September 2006 on batteries and accumulators. Please dispose of batteries and accumulators according to the relevant legal requirements. Operating manual – particle counter PC220...
Page 16
Trotec GmbH & Co. KG Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...
Need help?
Do you have a question about the PC220 and is the answer not in the manual?
Questions and answers