EtroVISION EtroScan EV8782 Series Quick Installation Manual

Download this manual

EV8782 Series–Quick Installation Guide

1 Install EtroScan on a Windows PC

EtroScan™ is a utility is used to configure network settings for cameras & video servers. EtroScan™ is available on the

CD-ROM or can be downloaded from the Tools section at http://www.etrovision.com/Download_list.aspx?no=5.

Run Setup.exe to install EtroScan™.

2 Basic Physical

installation

Please review the steps before starting. The steps

outlined below are the suggested installation path, but

certain steps may need to be switched depending on

the installation environment.

1. Fix camera to wall (or other surface) for mounting

by using the 2 wall mount screws in the mount

holes.

2. The cable connections are as shown.

3. If using 12V DC, use the terminal block bridge and

power cable adapter supplied in the plastic

packaging.

WARNING: Disconnect power before opening the

camera to avoid electrical accidents.

If PoE will be used (not using 12V DC), use the

RJ45 Network cable port for PoE.

4. To adjust the lens, use the 2

access in the inside of the camera; unscrew the

front glass cover to remove the cover.

E41000001600

reset button or

Need help?

Do you have a question about the EtroScan EV8782 Series and is the answer not in the manual?

Page 1 1 Install EtroScan on a Windows PC EtroScan™ is a utility is used to configure network settings for cameras & video servers. EtroScan™ is available on the CD-ROM or can be downloaded from the Tools section at http://www.etrovision.com/Download_list.aspx?no=5. Run Setup.exe to install EtroScan™.
Page 2 PCB boards. The SD card slot is near the back. 3 Configure the Network Settings The factory default IP address settings: IP Address 192.168.1.2 Subnet Mask 255.255.255.0 Gateway 192.168.1.1 Run EtroScan™ (program available via Start -> All Programs -> Etrovision Technology menu)
Page 3 4 Access IP Camera Web Interface When accessing an IP camera using the web interface for the first time (or when the IP address changes), some configuration for ActiveX controls are required. 1. Open an IE browser 2. Type in the IP address in the URL: http://<IP ADDRESS> (e.g. http://10.1.21.53) Pop-up windows and messages for download/run Active X controls (examples below) will likely be displayed.
Page 4 5 Restoring Factory Default Settings There are 2 methods for restoring the factory default settings: 1. Power on the camera, push and hold down the reset button (either the cable reset button or the reset button above the camera lens) for 6 seconds. The camera will revert to factory default settings (e.g. IP will reset to 192.168.1.2). 2.