Accessories Included; Getting Started; Power Source - Jensen JBS-200 User Manual

ACCESSORIES INCLUDED

Carefully remove the unit and all accessories from the package.
Please verify that you have all the following accessories before recycling the gift box.
Main Unit

2 x Speakers

User Manual

 Remote control
Connecting the Speakers
Each speaker cable has a plug on the end that fits into the speaker connector located on the back
of the main unit. Make sure the little tab on the top of the plug is facing up when inserting it into the
connector. The plug goes in only one way, so do not force the plug into the connector or it may
cause damage.

POWER SOURCE

This unit operates on 120 VAC ~ 60 Hz AC household current and requires one CR2025 3V
lithium battery (included) for the remote control. Do not attempt to operate the unit from any other
power source. You could cause damage to the unit and void your warranty.
AC Power Connection
Plug the AC power cord into an available 120V~ 60Hz AC Outlet. Make sure the plug is securely
inserted into the AC outlet.
Installing the Batteries for the Battery Back-Up
1. Remove the battery compartment door located on the bottom of the main unit.
2. Follow the polarity markings inside the battery compartment, and insert 2 x AAA batteries (not
included) into the two battery slots located in the battery compartment.
3. Replace the battery door.
NOTES:
When replacing the back-up batteries, do not disconnect the AC power cord from the wall outlet. If you

do, all the current date time and alarm settings will be erased.
 If the unit will be left unplugged for a long period of time, remove the batteries to avoid any damage that
may occur if the batteries leak and cause corrosion.

GETTING STARTED

Remote Control
The remote control operates on one CR2025 3V lithium battery
(included in the remote). To activate the remote control, remove
the insulator tab inserted in the battery compartment.
If the remote operation becomes intermittent or unsatisfactory,
replace the original battery with a new CR2025 3V lithium battery.
1.Press down on the compartment cover, slide out the battery
holder from the remote control case.
2.Replace the battery making sure the battery is installed correctly.
The remote will not work if the battery is installed with the wrong
polarity.
CAUTION:
1.) Danger of explosion if the battery is replaced incorrectly.
2.) Replace only with the same or equivalent type battery.
3.) Insert the battery holder back into the battery slot.
NOTE: Only use a well-known brand of battery to ensure the
longest life and best performance.
E-8