Options; Before First Use - AEG F55412VI0 User Manual

10 www.aeg.com
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously

7. OPTIONS

Desired options must be
activated every time before
you start a programme.
It is not possible to activate
or deactivate options while a
programme is running.
Not all options are
compatible with each other.
If you have selected non
compatible options, the
appliance will automatically
deactivate one or more of
them. Only the indicators of
the options still active will
stay on.
7.1 XtraDry
Activate this option when you want to
boost the drying performance. With the

8. BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
and
until the indicators
and
and the display is blank.
2. Press
• The indicators
off.
• The indicator
continues to flash.
• The display shows the current
setting:
–
–
3. Press
setting.
4. Press the on/off button to confirm
the setting.
,
use of this option, the duration of some
programmes, water consumption and
the last rinse temperature can be
affected.
The option XtraDry is not a permanent
option and must be selected at every
cycle.
How to activate XtraDry
Press simultaneously
. The indicator
If the option is not applicable to the
programme, the related indicator does
not come on or it flashes quickly for a
few seconds and then goes off.
The display shows the updated
programme duration.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the
baskets.
When you start a programme, the
appliance can take up to 5 minutes to
recharge the resin in the water softener.
start to flash
.
and
= Acoustic signal off.
= Acoustic signal on.
to change the
and
comes on.
go