Bushnell TOUR X Jolt Manual page 10

UNIT OF MEASURE OPTIONS
The Tour® X Jolt® can be used to measure distances in yards or meters. The unit of measure indicators are located in
the lower right portion of the display. There are two measuring settings to choose from and this is the second setting
within the SETUP menu. Look through the eyepiece, depress the "MODE" button ("B" Button on side of device)
and hold it down for approximately 3 seconds to get into the SETUP menu. Depressing the MODE button will toggle
through the brightness settings if the bright red LED display is selected. If you are changing from yards to meters,
a change in unit of measure will be indicated by the illumination of the M for meter indicator while the Y for Yard
indicator is turned off. If you are changing from meters to yards, the opposite will occur. The Tour® X Jolt® will return
to the last unit of measure setting used each time the unit is turned on.
PRODUCT CARE
CLEANING
Gently blow away any dust or debris on the lenses (or use a soft lens brush). To remove dirt or fingerprints, clean with a soft
cotton cloth, rubbing in a circular motion. Use of a coarse cloth or unnecessary rubbing may scratch the lens surface and
eventually cause permanent damage. For a more thorough cleaning, photographic lens tissue and photographic-type lens
cleaning fluid or isopropyl alcohol may be used. Always apply the fluid to the cleaning cloth – never directly on the lens.
10