Table of Contents
Advertisement
EXCELL PRECISION CO., LTD.
Preset "Beeper value" ( Refer to Note )
Press
Press
Press
Press
Press
Preset Single point (preset low limit only):
After "preset low limit" procedures is completed and the display shows
, then press
"preset single point" procedure is completed.
NOTE
_
Setting for the status that LCD is on and the beeper beep:
A
0 = when stable, the beeper beeps and LCD is on.
1 = when stable, the beeper beeps; whether stable or not, LCD is on.
2 = whether stable or not, the beeper beeps and LCD is on.
3 = open warning device: when the weight is higher than HI value and the
weight is stable, LCD is on and Relay Card open.
Setting for the beep status:
B
0 = No beep
1 = OK (when the weight is over Low Limit & under or equal to High Limit.),
the beeper beeps.
2 = When the weight is under or equal to Low Limit & over High Limit, the
beeper beeps.
Under Status in Preset Low Limit (preset single point only)
The BEEP, LCD mode should be fixed as follows:
Warning device setting
Set HI value and value of the beep, LCD mode should be fixed as follows:
When the weight equals to HI value, Relay Card open and the weight is accumulated.
Press CE key to dismiss the warning sound and the range of accumulated weight is
[000.000]~[999999].
Clear warning accumulation
♦ Press
key first and then press
♦ Accumulated data is cleared automatically under in following conditions
a. when shift among weight mode, counting mode and warning accumulation mode.
b. when shift the units
c. turn off the scale
02018058
key 1 time
the display shows
key 2 times
the display shows
key 1 time
the display shows
key 2 times
the display shows
key 1 times
the display shows
key again, the display shows
x
x
_
_
A
B
When over "Low Limit", the beeper beeps and
Whether stable or not, the beeper beeps and LCD indication is on
Β
A
e.g. Beeper value = 22
.
key to clear all accumulated data.
9
.
.
. This means that the
is off
ZSME300000317
Advertisement
Table of Contents
