Heat Sink Assembly - HP 255 G6 Maintenance And Service Manual

Heat sink assembly

NOTE: The heat sink assembly spare part kit includes replacement thermal materials.
Description
Heat sink for use in models with UMA graphics and AMD dual core, 6 W processors
Heat sink for use in models with UMA graphics and AMD dual core, 15 W processors
Heat sink for use in models with UMA graphics memory and AMD quad core processors
Heat sink for use in models with discrete graphics memory and AMD dual core processors
Heat sink for use in models with discrete graphics memory and AMD quad core processors
NOTE: To properly ventilate the computer, allow at least 7.6 cm (3.0 in) of clearance on the left side of the
computer. The computer uses an electric fan for ventilation. The fan is controlled by a temperature sensor and
is designed to turn on automatically when high temperature conditions exist. These conditions are affected by
high external temperatures, system power consumption, power management/battery conservation
configurations, battery fast charging, and software requirements. Exhaust air is displaced through the
ventilation grill located on the left side of the computer.
Before removing the heat sink assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
To remove the heat sink assembly:
1. Refer to the following heat sink removal image that matches your computer.
2. In the order indicated on the heat sink, remove the screws that secure the heat sink assembly to the
system board.
3. Remove the heat sink assembly from the system board.
NOTE:
Discrete graphics
56 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
Optical drive on page
Bottom cover on page
Heat sink appearance may vary.
30).
31), if installed.
38).
Spare part number
925019-001
925020-001
925017-001
925021-001
925018-001