About The Laser Pointer - Hitachi CP-X807(EDX50WL) Service Manual

6-4-2 Potting batteries into the remote control
• Use the batteries included in this product or two new batteries of the specified type: HITACHI MAXELL,
part number LR6 or R6P.
1. Remove the battery cover.
Slide back and remove the battery cover in the direction of the arrow.
2. Insert the batteries.
Align and insert the two AA batteries according to their plus and minus terminals as indicated in the
remote control.
3. Close the battery cover.
Replace the battery cover in the direction of the arrow and snap it back into place.
Changing the frequency of remote control signal
The accessory remote control has the choice of the mode 1 or the
mode 2, in the frequency of its signal.
If the remote control does not function properly, attempt to change the
signal frequency. Please remember that the "REMOTE FREQ." in SER-
VICE item of OPTION menu of the projector to be controlled should be
set to the same mode as the remote control.
To set the mode of the remote control, slide the knob of the frequency
switch inside the battery cover into the position indicated by the mode
number to choose.

About the Laser pointer

• The laser pointer of the remote control is used in place of a fi nger or rod. Never look directly into the laser
beam outlet or point the laser beam at other people. The laser beam can cause vision problems.
• Use of controls or adjustments or performance of procedures other than those specifi ed herein may result
in hazardous radiation exposure.
This remote control has a laser pointer in place of a fi nger or rod. The laser beam works and the LASER
INDICATOR lights while the LASER button is pressed.
CP-X807(EDX50WL)
WARNING
CAUTION
LASER INDICATOR
LASER button
29
Back of the
remote control
Inside of
the battery cover
2
Frequency switch
1