Bruno VPL-3100 Installation Manual page 30

INSTALLATION
MOVING THE RAMP, RAMP ACTUATOR
AND VERTICAL BAR TO THE OPPOSITE
SIDE OF THE PLATFORM (continued)
Once the bracket screws
are loosened, hold onto the
ramp. It is now free and will
slide off the platform.
Also, keep track of the (2)
nylon washers on the ramp
tube peg. They can easily
slide off and be misplaced.
above: (3) screws to remove from
bracket.
below: bracket removed, showing
fixed shoulder washer and loose
washer on peg (don't loose it!)
©2008,2006 Bruno Independent Living Aids, Inc.®
Ramp
1. On the side opposite the actuator wheel,
remove the (3) screws securing the bracket
(see lower left).
2. While holding the ramp, slide the bracket off
the peg (see note to left).
3. Slide the ramp out of the bracket on the
other side.
4. Set the ramp on the ground.
3. Take the screws and washer removed in
Step 1 and insert back into their respective
holes to secure the platform barrier.
4. Mount the bracket just removed on the cor-
ner diagonally across from its original corner.
Remount
bracket to
platform in
diagonal
corner.
ramp removed
5. Remove the second bracket (same side as
the ramp actuator wheel).
6. Lay this second bracket near the corner
diagonally opposite the corner from which it
was just removed.
7. Move the ramp to the opposite side of the
platform.
30
platform (view
from top)
bracket from
this corner.
VPL-3100 06-02-2008
Remove