Wiring The Call/Send And Gate - Bruno VPL-3100 Installation Manual

INSTALLATION
WIRING THE CALL/SEND
AND THE GATE
electrical
box
6-wire
gate
3-wire
call/send
©2008,2006 Bruno Independent Living Aids, Inc.®
Bruno provides wiring harness kits for the call/
send and the gate. You will use the items in the
kits to connect to the wiring harness near the
bottom of the lift.
The 6-wire harness connects to the gate
(includes call/send wiring) .
The 3-wire harness connects to the
remote call/send .
CALL/SEND
1. Remove the 3-wire harness from the kit.
2. Connect this harness to the corresponding
harness from the VPL electrical box.
3. Route the harness through the plastic clips
located at the base of the VPL tower.
4. Thread the harness through the punchout in
the side of the tower.
NOTE: There is an access hole on each side of
the tower. You may use either side.
5. Continue routing the harness to location
where the call/send box will be mounted.
6. Skip to "Mounting the Call/Send Box"
instructions on the next page.
22
VPL-3100 06-02-2008