Magnavox MRD-250 User Manual page 13

mrd250book 2/14/03 10:49 AM Page 13
Connect the DVD Receiver's S-VIDEO OUT jack to the
1
S-VIDEO IN jack on your TV. You will need an S-Video cable
(not supplied).
To hear TV channels through the DVD Home Cinema System,
2
connect the supplied red and white audio cables to the
DVD Receiver's red/white, right/left AUDIO IN jacks and to
the TV'S right/left AUDIO OUT jacks. Match the cable colors
to the jack colors.
Connect the power cords of the DVD Receiver and TV to a
3
power outlet.
Turn on the TV and set it to the correct S-Video In chan-
4
nel. Go to the lowest TV channel and change channels down until
you find the S-Video In channel. (It is not channel 3 or 4 as it might
be when using a VCR.)
5 Press STANDBY-ON y y on the front of the DVD Receiver to
turn on the DVD Receiver. The red Standby light will disappear.
It is not necessary to set VIDEO OUT to S-VIDEO.
6
S-VIDEO is the DVD Receiver's default setting. However, if your
picture is distorted, check the VIDEO OUT setting. Make sure it is
set to S-VIDEO.
Connecting to a TV with an S-Video In jack
2
FR FL C
SPEAKERS
See your TV owner's manual for details.
Details are on page 22.
Hookups - TV (cont'd,) 13
CENTER AUDIO AUDIO VIDEO
LINE OUT OUT IN OUT
L
AM/FM
ANTENA
R
AM
(75‰)
SR SL
WOOFER S- VIDEO
TV AUX
LINE OUT OUT
(8‰)
Pr/Cr Pb/Cb Y COAXIAL OPTICAL
COMPONENT DIGITAL
VIDEO OUT
OUT
1
3
FM
Helpful Hints
• You only need one video connec-
tion between the TV and the
DVD Receiver. You cannot use S-
Video and Component Video at
the same time.
• If you used the yellow VIDEO
OUT jack on the DVD Receiver
to connect it to the TV, you do
not need to adjust the VIDEO
OUT setting.