Problem
lights up
Bars flash in the display
at the end of a
programme:
.........
flashes/lights up
after the tumble dryer
has been switched on
and a programme
cannot be selected
and light up after
a programme has been
cancelled, a signal
sounds
and another number
combination flash after
a programme has been
cancelled, a signal
sounds
: lights up and the
programme has been
cancelled, a signal
sounds
Cause and remedy
The programme selector has been moved.
Select the original programme. The time remaining
will appear in the display again.
The programme has finished but the laundry has not
yet cooled down.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
Access via a code has been activated.
See "Programmable functions - Code".
An excessive amount of fluff has built up.
Clean the fluff filters.
Clean the plinth filter.
Clean the airways: the area underneath the plinth
filter and the heat exchanger.
See "Cleaning and care".
To switch off:
Switch the dryer off and then on again.
You can influence this error message yourself: see
"Programmable functions" and the part on the "
Airways indicator".
No obvious cause.
Switch the dryer off and then on again.
Start a programme.
If the programme is cancelled again and an error
message appears, there is a fault. Contact the Miele
Service Department.
The laundry is unevenly distributed or has rolled up.
Disentangle the laundry and remove a few items, if
necessary.
Switch the dryer off and then on again.
Start a programme.
What to do if ...
49