Table of Contents
Advertisement
MAINTENANCE AND CARE
OF YOUR RAPID RELEASE PRO2 MASSAGER
Clean your Rapid Release Pro2 with premoistened wipes. Do not use
solvents such as benzene, paint thinner, or acetone.
Your Rapid Release Pro 2 is made from the highest quality ABS,
polycarbonate and polymer plastics. Please do not use massage oils or
lotions that contain aromatic oils as they can cause deterioration of the
plastic and power cord rubber, damaging your Rapid Release Pro2 device.
Do not store or place Rapid Release Pro2 where it can drop or fall
into water.
Do not use continuously for more than 10 minutes. Please allow it to
cool off 5–10 minutes before the next use.
BASIC USAGE INSTRUCTIONS
Session time is typically 2 to 5 minutes.
1. Turn on by pushing gray switch on the rear of the Rapid Release Pro2
to the Right.
2. Use a grip that is comfortable to you, making sure that you are not
obstructing the air vents.
3. Rotate the Rapid Release Pro2 so the desired treatment head is in
contact with the body.
4. When using for the first time on somebody, ask them to hold out
their hand with palm up and apply Rapid Release Pro2 to confirm it is
acceptable to them.
5. Applying pressure is not needed or recommended. Let the weight of
the Rapid Release Pro2 do the work for you.
6. Keep the device moving about 1 inch per second in a circular or
zig zag motion.
7. The Rapid Release Pro2 can be used on skin or clothing.
8. Do not pull or tug on the power cord. Doing so could damage the cord
or cause a power disconnect where the cord connects at the base of
the Rapid Release Pro2. This may void your warranty.
9. It is normal for the green disk to become warm to the touch. Like any
mechanical device, while in use, it is normal for the areas near the
ventilation slots to become warm. If this area becomes hot, turn the
machine off and let it cool off for ten minutes before using it again.
10. Please visit RapidReleaseTech.com for more information.
10-008 Rev 5 02/28/17
4
Hide quick links:
Advertisement
Table of Contents
