Simple ISFM2351 Installation & Operation Manual page 8

TranzIt BLU HF
I. Additional Dipswitch Configurations
If the need arises to reset the module, or learn the value of the control button, there are
several dipswitch configurations that will be used:
Learning Mode:
Used to program the value of the control button. (this is not typically needed)
Note, it may take around 10-15 seconds for the module to enter learning mode,
after power is connected.
The Green LED will be solid illuminated when the module is ready for the control
button to be pressed.
Once the control button value is learned, all three LEDs will illuminate
(Red, Green, and Blue)
Factory Reset:
When LED flashes on back of module, settings are reset (about 1 second after
power connected)
Quick Green LED flash indicates module has been factory reset
NOTE: After a factory reset, you will need to enter learning mode, and learn the
value of the control button, for normal operation.
"Made for iPod," "Made for iPhone," and "Made for iPad" mean that an electronic accessory
has been designed to connect specifically to iPod, iPhone, or iPad, respectively, and
has been certified by the developer to meet Apple performance standards. Apple is not
responsible for the operation of this device or its compliance with safety and regulatory
standards. Please note that the use of this accessory with iPod, iPhone, or iPad may affect
wireless performance.
iPad, iPhone, iPod, and iPod touch are trademarks of Apple Inc., registered in the U.S. and
other countries. Lightning is a trademark of Apple Inc.
The Bluetooth
Inc. and any use of such marks by AAMP of America™ is under license. Other trademarks
1, and 3 ON (down)
1, and 4 ON (down)
word mark and logos are registered trademarks owned by Bluetooth SIG,
®
1 2 3 4
Learning Mode
1 2 3 4
Factory Reset