Program Chime; Set System - Detection Systems abacus 6R User Manual

Detection Systems
Hello XXXXXX

Set System?

YES: to Continue
No: to Quit
Omit Zones ?
1=Prog 2=Test
3=Log4=Day(Quit)
e
1=Code 2=Chim
3=Time 4=Engnr
Enter Code No. - -
Code 1 =Used
Master Bill
Code 3 >
Main Anne
1=Prog 2=Test
3=Log4=Day(Quit)
0712 03:46P
System Off
Hello XXXXXX
Set System?
YES: to Continue
No: to Quit
Omit Zones ?
1=Prog 2=Test
3=Log
4=Day(Quit)
At this display, press the NO key. (XXXXXX = Code holders name if
programmed).
On Version 7000 software, this display appears to allow you to return to the
day mode if you have made a mistake, press YES/PART key to continue.
At this display, press the NO key.
At this display, press the 1 key to enter the programming mode.
At this display, press the 1 key to enter the code-programming mode.
On Version 7000 software enter the code number you wish to change (see
system feature chapter 1)
At this display, press the YES/PART key to go the next code, repeat until
code to be deleted is displayed, press the NO key to edit, the = sign changes
to >. press the NO key again and check the word 'Used' disappears.
Press the YES/PART key (do not put any number in) Display will step to
next code. Repeat to delete further codes as required. (Abacus 8/80 to index
in 10s i.e. key in 3 to jump to code 30). On completion press 0/ESC once.
(Twice for mode 2 operation, Version 5000 software).
Press the 4 key to return to the day mode and check that the code has been
deleted, or press the number displayed, for function required.

Program Chime

From the day mode, enter the Main or Master code.
At this display, press the NO key. . (XXXXXX = Code holders name if
programmed).
On Version 7000 software, this display appears to allow you to return to the
day mode if you have made a mistake, press YES/PART key to continue.
At this display, press the NO key.
At this display, press the 1 key to enter the programming mode.
Chapter 4.21
Abacus User Guide