Code Programming; Programming Tips For Version 7000 Software - Detection Systems abacus 6R User Manual

Detection Systems

Programming tips for Version 7000 Software.

1. To delete the last letter, press 0/ESC key or YES/PART key followed by the NO key.
2. To delete the displayed text, press YES/PART key,0/ESC key followed by the NO key.
3. For fast exit, press YES/PART key followed by 0/ESC key then YES/PART key again.
4. When in library press the 0/ESC key to delete the current word displayed.
5. Press the YES/PART key to accept the letter or word
6. Press the YES/PART key twice for a space.

Code Programming

ONLY A MASTER CODE CAN PROGRAM USER CODES.
An Abacus panel, when it leaves the factory has only one user code set, code 1 is always a master code,
factory set to 1234, this code cannot be removed, it can be changed to any number 4 (4, 5 or 6) digits
you require (See System Features chapter 1). Should you attempt to delete code 1, it will revert to the
factory default of 1234.
0712 03:46P
System Off
Hello XXXXXX
Set System?
Press the NO key.
YES: to Continue
No: to Quit
?
Omit Zones
1=Prog 2=Test
3=Log4=Day(Quit)
1=Code 2=Chime
3=Time 4=Engnr
Enter Code No. - -
Code 1 =Used
Master
Code 1 >654321
Master
From the day mode, enter the User master code (1234).
At this display, press the NO key. (XXXXXX = Code holders name if
programmed).
On Version 7000 software, this display appears to allow you to return to the
day mode if you have made a mistake.
Press the YES/PART key.
At this display, press the NO key.
At this display, press the 1 key to enter the programming mode.
At this display, press the 1 key to enter the code-programming mode.
On Version 7000 software enter the code number you wish to change
(see system feature chapter 1)
At this display, press the YES/PART key to go to code 2 or press the NO
key to edit (code 1), the = sign changes to >.
changed press the YES/PART key, to change number press the NO key and
enter the new 4, 5 or 6 digit code required. (See System Features also
Abacus 6 old software code 7 Duress).
Press the YES/PART key, the > will move to either:
For code 2 and above towards code type (Master).
Chapter 4.19
Abacus User Guide
If the number is not to be