Table of Contents
Advertisement
4 Get started
Insert the remote control
batteries
1
Slide the battery cover off the back of the
remote control.
2
Insert the 2 supplied batteries (AAA). Be
sure the + and - ends of the batteries line
up with the markings inside the case.
3
Slide the cover back into position.
Note
•
Do not mix batteries (old and new or carbon
and alkaline, etc.).
•
Remove batteries if they are exhausted or if
the remote control is not to be used for a long
time.
•
Batteries contain chemical substances, they
should be disposed of properly.
Navigate through the menu
1
Point the remote control directly at the
remote sensor on the product and select
the desired function.
2
Press the following buttons on the
remote control to navigate through the
on-screen menus.
Button
/
/
OK
Find the correct viewing
channel
1
Press
( Standby ) to turn on this
product.
2
Press DISC to switch to disc mode.
3
Turn on the TV and switch to the correct
video-in channel in one of the following
ways:
•
Go to the lowest channel on your
TV, then press the Channel Down
button until you see the Philips or
the Home menu screen.
•
Press
SOURCE button repeatedly
on the remote control of your TV.
Tip
•
The video-in channel is between the lowest
and highest channels and may be called
FRONT, A/V IN, VIDEO, HDMI etc. See the
TV user manual on how to select the correct
input on the TV.
Action
Move up or down
Move left or right
ConÀ rm a selection
Enter numbers
Access to the Home
menu.
EN
19
Advertisement
Table of Contents
