Makita M1901 Instruction Manual page 8

Shiplapping (Rabbeting)
Fig.12
To make a stepped cut as shown in the figure, use the
edge fence (guide rule).
Draw a cutting line on the workpiece. Insert the edge
fence into the hole in the front of the tool. Align the
blade edge with the cutting line.
1
Fig.13
► 1 . Blade edge 2. Cutting line
Adjust the edge fence until it comes in contact with the
side of the workpiece, then secure it by tightening the
screw.
1
Fig.14
► 1 . Screw 2. Edge fence
When planing, move the tool with the edge fence flush
with the side of the workpiece. Otherwise uneven plan-
ing may result.
Fig.15
Maximum shiplapping (rabbeting) depth is 9 mm
(11/32").
You may wish to add to the length of the fence by
attaching an extra piece of wood. Convenient holes
are provided in the fence for this purpose, and also for
attaching an extension guide (optional accessory).
Fig.16
2
NOTE: The shape of the guide rule is differ from
country to country. In some country, the guide rule is
not included as a standard accessory.
Chamfering
2
Fig.17
8 ENGLISH