To Adjust Auto Thread Cutter Switch Position - Janome MC6300P Service Manual

The driving arm
(1) is raised.
(Sewing mode)
The driving arm (1) is
raised.
The LED shows "oF".
Driving arm (1)
Switch
Setscrew (A)

TO ADJUST AUTO THREAD CUTTER SWITCH POSITION

The driving arm
(1) is lowered.
Driving arm (1)
(Cutting mode)
The driving arm (1) is
lowered.
The LED shows "on".
1. While pressing the needle up/down and lock
stitch buttons, turn the power switch on. Press
the zigzag width minus button "
within 3 seconds.
2. Press the stitch length plus button "
twice. The LED shows "cL" in one second, then
"oF".
3. Remove the machine base and auto thread
cutter cover (refer to pages 2 and 3).
4. Set the needle bar at the lowest position.
5. Loosen the setscrew (A) and adjust the position
of the switch (B) as follows:
* When the driving arm (1) is lowered, the LED
shows "on".
* When the driving arm (1) is raised, the LED
shows "oF".
6. Attach the machine base and auto thread cutter
cover.
37
"
"