To Adjust Direction Of Presser Bar And Its Height - Janome MC6300P Service Manual

When the presser foot is lifted, the distance between the surface of the needle plate and the bottom of
the zigzag foot should be 6mm as shown in Fig 1.
When the presser bar is lowered, the presser foot should be parallel with the holes for the feed dogs as
shown in Fig. 2.
Presser bar
lifter
Zigzag foot
Fig. 1
Holes for
feed dogs

TO ADJUST DIRECTION OF PRESSER BAR AND ITS HEIGHT

Hexagonal
socket
screw (A)
6mm
To be parallele with
holes for feed dogs
Fig. 2
[ To adjust ]:
1. Remove the face plate (refer to page 1).
2. Lift the presser bar.
Loosen the hexagonal socket screw (A).
Adjust the direction and height of the presser
bar.
3. Attach the face plate.
16