Kenmore 110.31632610 Use & Care Manual page 19

If you experience
Washer not performing as expected (cont.)
Incorrect dispenser operation
Control panel not
Error Code Appears in Display
F1E1 ACU (Appliance
control fault)
F2E3 UI/ACU mismatch
F3E1 Water level
F5E2 Lid lock will not lock is
lid lock failure
F5E3 Lid cannot unlock
UI cannot communicate
TROUBLESHOOTING
Possible Causes
Control Lock is on.
tends more than 4.5" (114 mm)
into standpipe.
Internal ACU failure.
Pressure sensor on ACU failure.
Washer lid left open.
Drain extends more than 4.5" (114 mm)
into standpipe.
Load not balanced.
It is normal for small amounts of water to be remain in dispenser at the
dispenser. To avoid, select a warmer wash temperature if possible,
use the control panel.
See Installation Instructions.
Call for service.
Call for service.
Call for service.
Remove power from the washer. Let washer set for 5 minutes for the
error codes. If the error code persists call for service.
will drain.
Open the lid, redistribute the load, close the lid, and press START/PAUSE.
Solution
19