Page 1
PS07570 201205 MIG135 115 Volt MIG Welder Assembly & Operating Instructions READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THIS PRODUCT. This manual provides important information on proper operation & maintenance. Every effort has been made to ensure the accuracy of this manual. These instructions are not meant to cover every possible condition and situation that may occur.
Before use, read carefully and understand all warnings, cautions, instructions and labels. Failure to do so could result in serious personal injury, property damage or even death. IMPORTANT SAFETY RULES PS07570 MIG135 115 V MIG Welder Assembly & Operating Instructions Manual...
Page 3
Do not force tool. Use the correct tool for your application. The correct tool will do the job better and safer at the rate for which it was designed. PS07570 MIG135 115 V MIG Welder Assembly & Operating Instructions Manual...
Page 4
Do not drape cables over or around your body. Wear eye protection (see ANSI Z49.1 safety standard) while cutting to protect your eyes from harmful UV and IR ray’s. PS07570 MIG135 115 V MIG Welder Assembly & Operating Instructions Manual...
High voltage danger from power source! Consult a qualified electrician for proper installation of receptacle. This cutter must be grounded while in use to protect the operator from electrical shock. PS07570 MIG135 115 V MIG Welder Assembly & Operating Instructions Manual...
Page 6
Connect the Ground Clamp to a scrap piece of the same type of material which you will be welding. It should be equal to or greater than the thickness of the actual work piece, and free of oil, paint, rust, etc. PS07570 MIG135 115 V MIG Welder Assembly & Operating Instructions Manual...
50 PSI), the Low Pressure Indicator Light will not be lit up in those conditions. Adjust the air flow to be sure it is consistent. Pull the torch trigger. PS07570 MIG135 115 V MIG Welder Assembly & Operating Instructions Manual...
Page 8
• Be sure your work area is clean and secure. Be sure the area is free from all foreign material, nails, staples, or any other material. • Always use the appropriate safety gear when operating. Including but not limited to, goggles, dust mask or respirator. PS07570 MIG135 115 V MIG Welder Assembly & Operating Instructions Manual...