Summary of Contents for Buffalo Tools PS07569 Plasma 375
Page 1
PS07569 201412 Plasma 375 Plasma Cutter Kit Assembly & Operating Instructions READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THIS PRODUCT. This manual provides important information on proper operation & maintenance. Every effort has been made to ensure the accuracy of this manual. These instructions are not meant to cover every possible condition and situation that may occur.
When unpacking, check to make sure all parts listed are included. If any parts are missing or broken, please call Customer Service at 1-888-287-6981. FOR CONSUMER USE ONLY – NOT FOR PROFESSIONAL USE SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. PS07569 Plasma 375 Plasma Cutter Kit Assembly & Operating Instructions Manual...
Replace damaged cords immediately. Damaged cords increase the risk of electric shock. Don't overreach. Keep proper footing and balance at all times when operating this tool. PS07569 Plasma 375 Plasma Cutter Kit Assembly & Operating Instructions Manual...
Page 4
Do not cut if you are in an awkward position. Always have a secure stance while cutting to prevent accidents. Wear a safety harness if working above ground. PS07569 Plasma 375 Plasma Cutter Kit Assembly & Operating Instructions Manual...
Page 5
Torch Arc Starting Cable Connection This connector is for the red cable of the torch. It is used to help the arc starting. Torch Connection Connect the torch to the negative (-) receptacle. PS07569 Plasma 375 Plasma Cutter Kit Assembly & Operating Instructions Manual...
Page 6
3-pronged connector on the front of the plasma cutter. Be certain to properly align the notch in the connector with the grove in the plug. Connect the torch to the negative (-) receptacle. PS07569 Plasma 375 Plasma Cutter Kit Assembly & Operating Instructions Manual...
Page 7
Keep the torch’s nozzle vertical against the work piece, and watch to be sure the arc is moving along the cutting line. PS07569 Plasma 375 Plasma Cutter Kit Assembly & Operating Instructions Manual...
Page 8
• Be sure your work area is clean and secure. Be sure the area is free from all foreign material, nails, staples, or any other material. • Always use the appropriate safety gear when operating. Including but not limited to, goggles, dust mask or respirator. PS07569 Plasma 375 Plasma Cutter Kit Assembly & Operating Instructions Manual...