General
The 13ACD air conditioner, which will also be referred
to in this instruction as the outdoor unit, uses HCFC-22
refrigerant. This outdoor unit is intended as a replacement
outdoor component for use in residential systems which
include an existing indoor coil which is functioning properly.
It is NOT intended for new installations.
This outdoor unit is:
•
shipped from the factory with nitrogen holding charge
that must be purged from the unit;
Unit Dimensions - inches (mm)
SIDE VIEW
Model
13ACD-018-230
13ACD-024-230
13ACD-030-230
13ACD-036-230
13ACD-042-230
13ACD-048-230
13ACD-060-230
Parts Arrangement
GROUND LUG
SINGLE -POLE
CONTACTOR (K1)
Page 2 of 16
A
B
CONTROL BOX
Figure 1. Typical Unit Parts Arrangement
•
designed for use with HCFC-22 refrigerant only;
•
designed for use in systems that use either a RFC
device (orifice) included with outdoor unit or thermal
expansion valve (TXV). See the 13ACD product
specification sheet for approved fixed orifice sizes and
expansion valve kit match ups.
Important — The air conditioning unit must have properly
matched system components including indoor unit and
refrigerant metering device. Mismatched equipment may
have an impact on the operation, performance, reliability,
and warranty of the air conditioning unit.
OUTDOOR COIL FAN
COMPRESSOR
SUCTION AND LIQUID LINE
CONNECTIONS
OPTIONAL UNIT STAND OFF KIT
(4) (FIELD-INSTALLED)
A
24-1/4 (616)
24-1/4 (616)
24-1/4 (616)
24-1/4 (616)
28-1/4 (718)
28-1/4 (718)
28-1/4 (718)
NOTE: PLUMBING LAYOUT
TWEEN MODEL SIZES.
DUAL RUN
CAPACITOR (C12)
LIQUID LINE
SERVICE VALVE
Issue 1720
A
Discharge Air
SIDE VIEW
B
25-1/4 (641)
25-1/4 (641)
33-1/4 (845)
33-1/4 (845)
29-1/4 (743)
37-1/4 (946)
33-1/4 (845)
SUCTION LINE
SERVICE VALVE
506694-01