Table of Contents
Advertisement
ASSEMBLY (REAR POSITION)
As supplied the front panel and PCB are assembled in the extrusion the correct way round for mounting at the rear of
the console.
Attach side trims ITEM 6 to the extrusion ITEM 7 using the self tapping screw supplied
2
Left hand side trim has a rebate for the IDC cable. Care should be taken not to trap the cable when attaching
the side trim.
Apply self adhesive facia ITEM 4 to the front panel ITEM 5 ensuring correct alignment with the meter
1
3
slots.
4
Remove screws from left hand extrusion and plastic end cap and slide out extrusion as shown.
It may be necessary to loosen screws "A" to enable side extrusion to slide.
S1SM1
Attach Meterbridge to sides of front panel as shown in using M3
5
screws supplied ITEM 1
Connect IDC cable as shown ensuring correct orientation.
1 3
ITEM 2 The
ALLEN & HEATH
Hide quick links:
Advertisement
Table of Contents
