Safety Rules - PowerTec UT1002 Owner's Manual

WARNING
climb on the universal stand; it could tip over, causing
serious injury.
universal stand is 500 lbs (227 kg).
universal stand to tip over.
stand outdoors or in a damp location.
not work on or place the universal stand legs on floor
surfaces that are slippery from sawdust, oil, water or
wax.
Visitors should wear the same safety equipment as the
operator.
always follow the safety instructions in the power tool's
operator's manual.
operating power tools.
parts. Loose clothes, jewelry or long hair can be caught
in moving parts. Always wear non-slip footwear. Tie
back long hair. Roll long sleeves above the elbow.
the work piece and secure it to a stable platform.
Holding the work piece by hand or against your body is
unstable and may lead to loss of control.

SAFETY RULES

tools.
may be loose.
being attached to the stand.
WARNING
For your own safety, read all of the rules and precautions
before operating tool.
WARNING
other than that for which it was designed.
WARNING
Always follow proper operating procedures as defined in
this manual even if you are familiar with use of this tool
stand or any tool used with this stand. Remember that
being careless for even a fraction of a second can result in
severe personal injury.
You must be familiar with the use of any tool or accessory
used with this stand. The supplier cannot be held
responsible for any accident, injury or damage incurred
while using this stand with any tool.
READ AND SAVE THESE INSTRUCTIONS
1
1