biodex 950-275 Installation & Operation Manual page 11

CONTENTS
Safety Lanyard and Safety Stop: Disconnecting the Safety Lanyard (to the left side of
Display/Control Panel) or pressing the red Safety Stop (to the right side of Display/Control
Panel on the upper frame) at any time will cause the treadbelt to immediately ramp down to a
full stop and reset to 0.0 mph. The Display will read <Safe> and the treadbelt will not restart
until the lanyard is once again in position or <Start> is pressed following use of the Safety Stop.
Display data is not lost in either case. Data accumulation will resume once the lanyard is recon-
nected or <Start> has been pressed. To fully abort an exercise session after pressing the Safety
Stop, press <Clear Display>.
Figure 1. The RTM 400 Numeric Display/Control Panel.
— 11 — NUMERIC DISPLAY/CONTROL PANEL