Table of Contents
Advertisement
2. MONITORING
Under standby status, you can press monitoring button (
setting key to switch video from camera unit No 1 to No 2 if any. See above images. The monitoring time last 60S for
maximum.
3. MONITOR CALL MONITOR
Under standby status, you can press （ON/OFF） button to call another monitor if any. If the other monitor receive the signal
and response by pressing （ON/OFF）button, a voice communication is established. This communication last 60S for
maximum.
V． SYSTEM SETUP
1). CODING PROCESS
If your system has only one monitor and one camera unit, you do not need coding process. The IDs have been existing with
monitor and camera unit before ex-factory. This process is only needed for following cases:
1.
The units do not recognize each other under extremly rare circumstances, such as lightening;
2.
You need to increase monitor or camera unit to exixting system.
Recoding for Existing Camera units and Monitor:
Step 1：Assume a monitor ( No 1 monitor for example) as the system master, press Brightness key and
same time while in standby status until "Monitor Working Indicator"light up constantly , the master will be in
Coding status.
Step 2： Constantly press "CALL" button on camera unit until a "Di-"sound, the camera unit will be in coding status.
Step 3： With in 16seconds, if both monitor and camera unit sound "Di-" "Di-" "Di-", that means coding success, the units
will return standby status automaticaly. If the coding fails, the both units only sound "Di-", also return standby status
automaticaly.
（图 5）
（Image 7）
（图 6）
) to view the video from camera unit No 1, and press music
ON/OFF BUTTON
2/7
button
Advertisement
Table of Contents
