III. SYSTEM FEATURES ........................................................................................................................................... 3
IV. USER INSTRUCTIONS ....................................................................................................................................... 3
V. SYSTEM SETUP.................................................................................................................................................... 2
BRASH IMPORTS DIGITAL WIRELESS VIDEO DOOR PHONE SYSTEM MODEL: 7486DWL,7130DWL,7310 DWL I. CAUTIONS................................2 II. PACKING LIST..............................2 III. SYSTEM FEATURES ............................3 IV. USER INSTRUCTIONS ............................3 V. SYSTEM SETUP..............................2 VI.SYSTEM INSTALLATION ............................ 4 VII. SPECIFICATIONS............................... 6 www.brashimports.com.au...
I. CAUTIONS Shock Hazard--to prevent fire or shock hazard, do not expose the unit to rain, moisture or other liquid and do not overload the power cord. Instructions--Read and keep the instructions-all safety and operating instructions should be read and followed before the unit is operated Power Sources -- This equipment should be operated only from the type of power source indicated on the marking label and the power cord protection is needed.
III. SYSTEM FEATURES Maximum 2 cameras and 2 monitors same time in a system. Choosing 2.4G ISM digitalpublic frequnce resource:2402~2483.5MHz. Transmitting at 20dBm,Receving -100dBm; With 8~12 digital audio serial input, DAC output, 8K audio aquizition for good audio quality. And audio volue presetable in 4 levels.
Page 4
1— Rain Shelter; 16— Communication On/Off Button; 2— Working Indicator for Camera Unit (Blue 17— Audio Volume Setting Key; Color); 18— Color Setting Key; 3— Microphone; 19— Desk Top Talking On/Off Button; 4— Camera; 20— Battery Ready Indicator(Green); When 5— Infrared Led;...
2. MONITORING (图 5) (图 6) Under standby status, you can press monitoring button ( ) to view the video from camera unit No 1, and press music setting key to switch video from camera unit No 1 to No 2 if any. See above images. The monitoring time last 60S for maximum.
Page 6
Increase Monitor or Camera Unit: Step 1: Press Brightness key and button same time while in standby status until “Monitor Working Indicator”flicks , the master is ready to code the new devices to existing system. Step 2:Press Brightness key and button on the 2 monitor same time while in standby status until “Monitor Working Indicator”flicks , the monitor is ready for coding to the existing system.
While the monitor is in Communication status, you can press “Voice Volume Setting Key” (Image 12) to set the monitor’s voice volume. The voice volume increases each level after one pressing, but it will return to the lowest level after one pressing if the volue has been in the highest level. The alteration cycle is: 1→...
Page 8
The monitor(s) will be functioning when the battery is charged properly. 2)CAMERA UNIT(S) ( ( Image Image 16) 17) Camera unit 7139DWL is a surgace mounting device. The installation steps are: Choose a proper place on door or on side of door, that is about 145cm from the ground. Drill two ∮8mm holes with depth more than 50mm.
Terminal 1, 2, 3 of power supplier are for lock connection. Terminal 1 and 2 are used for 12V, NO (Normaly Open) locks, say giving power to open, such as punchturing locks. Terminal 2 and 3 re used for 12V, NC (Normaly Closed) locks, say breaking power to open, such as elcteo-maganetic locks.