Decware SE84UFO Owner's Manual page 5

OWNERS MANUAL for Model SE84UFO PAGE 5
f
HOOK-UP
Sources
SOURCE B!
SOURCE A!
RIGHT CHANNEL
RIGHT CHANNEL
SOURCE B!
SOURCE A!
LEFT CHANNEL
LEFT CHANNEL
This amplifier has been designed in such a way that you may use it
with or without a pre-amp. To that effect it has been equipped with
both a volume control and a simple source selector to allow you to
switch between two line level source components, such as a CD
Preamps
Player/DAC and anything else.
If using a preamp, connect the output of the preamp to one of the two
sources on the amplifier and set the amplifier's volume control
somewhere between 1/2 way up and full. Use the volume control on
your preamp to adjust listening volumes.
This amplifier requires 2 volts to come to full power. 2 Volts is the
average output signal level found in line level devices such as CD
Sensi>vity
players and DACs. This means that you will have to turn the volume
control nearly all the way up to make the amplifier clip (run out of
power) which keeps the clipping "kind" and harmless to not only the
amplifier but also the tubes and the speakers.