Decware SE84UFO Owner's Manual page 6

OWNERS MANUAL for Model SE84UFO PAGE 6
HOOK-UP
Power
POWER SWITCH
POWER CORD JACK
FUSE
3 AMP!
5x20 mm!
Make sure power cord is fully inserted into
power cord jack. A loose cord can cause reliability issues with the
tubes and poten>ally the amplifier itself.
We recommend plugging your amp directly into a new hospital grade
duplex outlet with a secure ground.
Consumer grade power condi>oner's are not recommended as most
of the noise they filter out of the power they inject into the air which
is then re-absorbed by the glass tubes causing worse sound than if no
condi>oner was used. Excep>ons are Isola>on transformers such as
the "Triplite" brand model ISO-500 or a power re-generator. Always
try to avoid power strips or extension cords whenever possible as they
can cause ground loops between your components resul>ng in hum.
We recommend the ISO-500 when power condi>oning is desired or a
simple alterna>ve to cheap power strips is needed as each ISO-500
comes with 4 outlets
NOTE: 220 ~ 240 VAC amplifiers should use a 1.6 AMP fuse.