Incidents During Operation; Maintenance - Husqvarna TS 510 G Operator's Manual

Stop the unit by putting the Stop Switch (19) into
the "Stop" (Off) position. Wait for all blade move-
ment to stop before removing material from the
machine.
Emergency: In an emergency situation
turn the Stop Switch (19) to the STOP
(OFF) position.

6. Incidents During Operation

• If the engine or motor stops during sawing,
check the following:
1. Out of fuel: Check fuel level.
. Low Oil Level: This unit is equipped with a
shut down system that stops the engine if
a low oil level is encountered. Check the
engine oil level while the engine is in a hori-
zontal position.
• If the engine or blade stalls for any reason, raise
the blade completely out of the cut, inspect the
machine thoroughly before restarting. When
lowering the blade into a partial cut, align the
blade exactly with the cut to prevent damage to
the blade.
• Excessively fast cutting will stall the engine.
• If the blade stops during sawing check that the
drive belt tension is adequate.

7. Maintenance

WARNING!
Before performing any maintenance, ALWAYS
locate the machine on a level surface with the
engine OFF, and the Stop switch in the OFF posi-
tion.
Check Daily:
• Clean the reservoir pan [of Frame Assembly
(1)] to remove sludge and slurry. This concrete
slurry is an abrasive cutting compound and will
shorten the life of the Water Pump (4) and the
Diamond Blade (6). Clean the reservoir pan
twice a day in heavy cutting. Then refill the
water reservoir pan with clean water.
• At the end of each day clean the water reservoir
pan [of Frame Assembly (1)] to remove sludge
from the saw. Flush clean water through the
Water Pump (4) and hoses.
• Check engine air cleaner daily! If cutting dry
check engine air cleaner every four hours! Clean
or replace air cleaner element as recommended
by the engine manufacturer.
• Check engine oil daily. Change engine oil after
every 50 hours of operation. Engine Oil capacity
is shown below. See engine operation manual
for proper care and maintenance.
Every 50 Hours:
• Change Engine Oil:
Change Engine Oil: Change
engine oil after every 50 hours of
operation.
Engine Oil Type:
Under normal operating conditions use SAE 10W30
API service classification SF or SG. See engine
operation manual for other recommended oil types.
Engine Oil Capacity (9hp & 13hp Honda):
1.16 U.S. Quarts, 1.1 Liters.
Engine Oil Change Procedure:
1. Drain the oil while the engine is still warm to
assure rapid and complete oil drain. Place a
bucket under the Oil Drain Hose (0) to catch
the used oil. Remove the Oil Drain Plug () on
the end of the Oil Drain Hose (0) and wait for
all of the used oil to be drained for the engine.
. Re-install and securely tighten the Oil Drain
Plug ().
3. Re-fill engine with the recommended oil type.
See the engine operation manual for the oil
fill location and proper oil level. Note that the
required oil capacity will be larger because of
the volume of oil contained in the Oil Drain
Hose (0).
4. Re-install the oil fill cap after filling engine with
oil.
5. Dispose of the used oil in a proper container
and in a manner that is compatible with the
environment.
18