Fitting The Blade; Operating Instructions - Husqvarna TS 510 G Operator's Manual

WARNING!
Only use Lifting Sling approved for overhead lift-
ing. Using Improper Lifting Sling can result in inju-
ry or death of operator or persons in work area!

4. Fitting The Blade

• The blade rotates in a "down-cut" direction. This
means that the front of the blade is moving
downward while the rear of the blade is moving
upward. Mount the Blade (6) so that the arrow
on the blade rotates in this "down-cut" direction.
The Blade (6) can be installed or removed by
using the 3/4" (19 mm) end of the Wrench (7)
provided.
• After mounting the Blade (6), it should align over
the top of the wooden insert in the Conveyor
Cart (). During operation of this unit, the blade
should pass into the wooden insert, but NOT into
the cast aluminum part of the Conveyor Cart ().
WARNING!
Use only Abrasive blades of a reinforced type.
Never use an abrasive blade with water.
Conventional "Wet" diamond blades MUST be
used with water.
DO NOT use conventional "Wet" diamond blades
without water. Using conventional "wet" diamond
blades without water can result in injury or death of
the operator or persons in the work area!
Mounting the Blade (6):
16
11 9
10
1. Using the Wrench (7) provided (or one of your
own) loosen the Capscrew (8) by turning it
Counter-Clockwise.
. Remove the Outer Flange (9) and make sure
the Outer Flange (9), the Inner Flange (10), and
Arbor Shaft (11) are clean and not damaged.
8
7
16
6
3. Mount the Blade (6) to the Arbor Shaft (11) and
install the Outer Flange (9). Install and tighten
Capscrew (8) by turning it in a Clockwise direc-
tion (Right Hand Thread). Use the Wrench (7)
to firmly tighten the Capscrew (8) to the arbor
shaft.

5. Operating Instructions

Configure the saw for wet or dry operation. Note
that the saw is factory assembled for dry operation.
Wet Operation:
WARNING!
Use only Abrasive blades of a reinforced type.
Never use an abrasive blade with water.
13
Fill the water reservoir pan [of the Frame Assembly
(1)] with water to within 1 inch (5 mm) of the top.
Be sure that the water pump intake Strainer (1) is
fully immersed in water at all times. Keep the intake
screen clean and free of sludge, slurry, or other for-
eign material.
Make sure the Water Valve (13) on the blade guard
is in the open position (Lever parallel with valve
body). Squeeze the Primer Pump (14) until water
flows out of the blade guard water tubes. Adjust the
water flow with the Water Valve (13), and check the
water flow before cutting.
15
9
8
7
17 14
12