Electrolux EWF12033 Troubleshooting Manual

TROUBLESHOOTING

9.1 Possible Failures
Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engineer.
Before contacting your local Service Centre,
please carry out the checks listed below.
Once the problem has been eliminated, press
the Start/Pause button to restart the program.
If after all checks, the problem persists,
contact your local Service Centre.
WARNING! Deactivate the appliance
before you do the checks.
Malfunction
The washing
machine does
not start:
The machine
does not fill the
water:
The machine fills
then empties
immediately:
Possible cause => Solution
The door has not been closed. (Error code:
door firmly.
The plug is not properly inserted in the power socket. => Insert the
plug into the power socket.
There is no power at the socket. => Please check your domestic
electrical installation.
The Start/Pause touchpad has not been pressed. => Press the
Start/Pause touchpad.
The "Delay End" has been selected. => If the laundry are to be
washed immediately, cancel the "Delay End".
The Main supply is unstable. (If
Wait until the main supply is stable. Appliance will start
automatically.
The water tap is closed. (Error code:
The inlet hose is squashed or kinked. (Error code:
the inlet hose connection.
The filter in the inlet hose is blocked. (Error code:
the water inlet hose filter.
The door is not properly closed. (Error code:
door firmly.
The end of the drain hose is too low. (Error code:
relevant paragraph in "water drainage" section.
Alarm Code:
The appliance does not fill with
water properly.
The appliance does not drain
the water.
The appliance door is open or
not closed correctly. Please
check the door!
The main supply is unstable.
Wait until the main supply is
stable.
No communication between
electronic elements of the
appliance. Switch off and
switch on again.
appears in the display.) =>
) => Open the water tap.
ENGLISH
) => Close the
) => Check
) => Clean
) => Close the
) => Refer to