Polar Refrigeration DN492-A Instruction Manual

Polar Refrigeration DN492-A Instruction Manual

Blast chiller / freezer
Hide thumbs Also See for DN492-A:

Advertisement

Telephone Helpline: 1300 225 960 (Australia)
1
Blast Chiller / Freezer
Instruction Manual
Model
DN492-A DN494-A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DN492-A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Polar Refrigeration DN492-A

  • Page 1 Telephone Helpline: 1300 225 960 (Australia) Blast Chiller / Freezer Instruction Manual Model DN492-A DN494-A...
  • Page 2: Safety Tips

    If the power cord is damaged, it must be replaced by a POLAR agent or a recommended qualified technician in order to avoid a hazard. Product Description DN492-A - POLAR Blast Chiller /Freezer DN494-A - POLAR Blast Chiller /Freezer Introduction Please take a few moments to carefully read through this manual.
  • Page 3: Installation

    Telephone Helpline: 1300 225 960 (Australia) Installation Note: If the appliance has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before operation. If in doubt allow the appliance to stand. 1. Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are thoroughly removed from all surfaces 2.
  • Page 4 Telephone Helpline: 1300 225 960 (Australia) Turning on In order to switch the unit on, press button. This will place the unit on standby whilst waiting for the cycle to be selected. Inserting the food insert probe Before selecting which cycle to use, the probe must be inserted into the food product.
  • Page 5: Manual Defrost

    Telephone Helpline: 1300 225 960 (Australia) How to stop a cycle If you have selected a chill operation, press and release the key. If you have selected a freeze operation, press and release the key. The unit will then switch off. When a Cycle is Running Display Temperatures The upper display (in red) shows the temperature of the inside of the cabinet.
  • Page 6: Cleaning The Evaporator

    Telephone Helpline: 1300 225 960 (Australia) Cleaning the evaporator Please ensure that the Blast Chiller is switched off and unplugged prior to cleaning  Clean the evaporator periodically.  As the fins of the evaporator are very sharp. Always wear protective gloves for the next phases ...
  • Page 7: Troubleshooting

    Telephone Helpline: 1300 225 960 (Australia) Troubleshooting If your POLAR appliance develops a fault, please check the following table before making a call to the helpline or your local POLAR retailer. Fault Probable Cause Required Action Check the unit is plugged in correctly and The unit is not switched on switched on Plug and lead are damaged...
  • Page 8: Technical Specifications

    Freeze Weight Model Voltage Power Current Capacity Ambient Chill Rate Rate (Kg) Temp ( 90 min 240 min DN492-A 230v 50Hz 770W 3.5A 3 x GN1/1 (12kg) (8kg) 90 min 240 min DN494-A 230v 50Hz 1300W 6.5A 10 x GN1/1...
  • Page 9: Electrical Wiring

    Telephone Helpline: 1300 225 960 (Australia) Electrical Wiring The plug is to be connected to a suitable mains socket. POLAR appliances are wired as follows:  Live wire (coloured brown) to terminal marked L  Neutral wire (coloured blue) to terminal marked N ...
  • Page 10: Declaration Of Conformity

    Telephone Helpline: 1300 225 960 (Australia) DECLARATION OF CONFORMITY Blast Chiller Equipment Type DN492-A, DN493-A, DN494-A Model C-Tick Legislation AS/NZ 3820 Essential Safety Requirements for Low Voltage Electrical Equipment AS/NZS CISPR 14.1:2010 Standards AS/NZS 60335.2.89:2010 POLAR Producer Name 15 Badgally Road,...
  • Page 12 DN492-A_DN494-A_v2...

This manual is also suitable for:

Dn494-a

Table of Contents