Disassembly Procedure For The Lens - Panasonic DMC-TZ7EB Service Manual

8.4. Disassembly Procedure for the
Lens
NOTE: When Disassembling and Assembling for the Lens
1. To minimize the possibility of the CCD being dirt, perform
disassemble and/or assemble under the condition of the
CCD is being mounted.
Disassembling procedures for the CCD unit, refer to item
8.6.
2. Take care that the dust and dirt are not entered into the
lens.
In case of the dust is putted on the lens, blow off them by
airbrush.
3. Do not touch the surface of lens.
4. Use lens cleaning KIT (BK)(VFK1900BK).
5. Apply the grease to the point where is shown to" Grease
apply" in the figure.
8.4.1. Removal of the Zoom Motor Unit
and Master Flange Unit
1. Remove the libs (5 points).
2. Unscrew the 5 screws (A).
3. Unscrew the 1 screw (B).
4. Unscrew the 1 screw (C).
5. Unscrew the 1 screw (D).
6. Remove the zoom motor unit.
7. Remove the master flange unit.
32