How To Discharge The Capacitor On Flash Top Pcb - Panasonic DMC-TZ7EB Service Manual

1.4.

How to Discharge the Capacitor on Flash Top PCB

CAUTION:
1. Be sure to discharge the capacitor on Flash Top PCB.
2. Be careful of the high voltage circuit on Flash Top PCB when servicing.
[Discharging Procedure]
1. Refer to the disassemble procedure and remove the necessary parts/unit.
2. Put the insulation tube onto the lead part of Resistor (ERG5SJ102:1kΩ /5W).
(an equivalent type of resistor may be used.)
3. Put the resistor between both terminals of capacitor on Flash Top PCB for approx. 5 seconds.
4. After discharging confirm that the capacitor voltage is lower than 10V using a voltmeter.
Fig. F1
4