Bluefin LED Piranha P3 Installation Manual

Advertisement

Bluefin Led Underwater lights.
P3 Installation manual.
Thank you for choosing Bluefin LED underwater lights, our products have been designed and tested
rigorously to ensure optimum performance and longevity.
All Bluefin Led lights are water tested so please be aware there may be moisture present on the light.
If you have ordered the Aluminium (A)option please be aware that these have been Hard PTFE
Anodised to form a corrosion resistant coating. Please take care not to damage this coating when
installing the light.
Please ensure that your product is installed as per our instructions below, failure to do so may
invalidate your warranty.
Specs: electrical/fuse ratings
Voltage
Piranha P3
12v only
Warnings:
Do not attempt to install the lights whilst the boat is in the water.
Ensure that the correct voltage is used for the light.
Ensure that an in line fuse is installed with the correct fuse rating per the light installed.
Ensure that use the Screws provided (failure to do so will invalidate your warranty).
Ensure all connections are made water tight.
Do not hold the light by the cable.
Do not use abrasives on the lenses.
Do not look directly into the light at close proximity
Tools required for installation:
2.5mm(3/32") drill bit
13mm(1/2") drill bit
Drill
Posi head hand screwdriver
Marine sealant 3M 4200 or equivalent
1
Current
1.2 amp
Fuse rating
3amp

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Piranha P3 and is the answer not in the manual?

Questions and answers

Summary of Contents for Bluefin LED Piranha P3

  • Page 1 All Bluefin Led lights are water tested so please be aware there may be moisture present on the light. If you have ordered the Aluminium (A)option please be aware that these have been Hard PTFE Anodised to form a corrosion resistant coating.
  • Page 2: Installation

    Please see the wire gauge guide attached to the instruction manual. For help with calculations always consult with a qualified professional or contact Bluefin LED directly. Attach the light cable to the VDC power on the boat ensuring that you use the in line fuse supplied connected to the positive(red) wire, ensure that you use the heat shrink provided to create a water tight fit into the fuse holder.
  • Page 3: Maintenance

    Piranha Gel Connector Instruction Manual. Thank you for choosing Bluefin LED underwater lights, our products have been designed and tested rigorously to ensure the optimum performance and longevity. Please ensure that your product is installed as per our instructions below, failure to do so WILL INVALIDATE YOUR WARRANTY.
  • Page 4 Service - Tel: 01827 880450 Email: mark.branson@bluefinled.com Administration - Tel: 01827 880450 Email: samantha.barrie@bluefinled.com Registered Address: Square Rig Limited, t/a Bluefin Led, Cottage Farm, Cottage Lane, Norton Juxta Twycross, Atherstone, CV9 3QH Company Registration Number: 08871451 VAT Number: 179 2690 64...

Table of Contents