Installing Onie On Cnos - Lenovo RackSwitch G8272 Quick Start Manual

Installing ONIE on CNOS

1. Download an ONIE image for the switch from the following link:
2. Upload the ONIE image to a local server or a USB drive.
3. Connect to the switch using the mini-USB serial console port. For more details, see
4. After connecting to the switch, enter Privileged EXEC configuration mode:
5. Use one of the following commands to copy the ONIE image:
16
Lenovo ONIE Quick Start Guide for G8272
To install ONIE on the switch running Cloud NOS, use the following steps:
Note: The commands used to install ONIE on the switch will display an error if the
ONIE license key is not installed.
http://support.lenovo.com/
For CNOS, the ONIE image is called Lenovo Rackswitch G8272 [ONIE]
10.x.x.0.
"Connecting to the G8272" on page
G8272> enable
G8272#
using FTP, SCP, SFTP, or TFTP:

cp ftp <FTP URL> system-image onie [vrf management]

cp scp <SCP URL> system-image onie [vrf management]

cp sftp <SFTP URL> system-image onie [vrf management]

cp tftp <TFTP URL> system-image onie [vrf management]

 using a USB drive:
cp usb1 <file path> system-image onie [vrf management]

Following is an example using the cp tftp command:
G8272# cp tftp tftp://10.72.97.98/onie-img/G8272-CNOS-10.1.1.0_ONIE.imgs
system-image onie vrf management
Confirm download operation? (y/n) [n] y
Download in progress
...
Copy Success
Install image...This takes about 90 seconds. Please wait
Valid image detected.
Check image signature succeeded
Extracting image: 100%
Installing ONIE:
Updating flash: 100%
Updating ONIE eeprom with manufacturing fields...
ONIE image installation succeeded.
ONIE image now contains Software Version 10.1.1.0
6.